TAIZHOU HEYA MOULD CO., LTD.

  Flower pot mould In the future, there is a lot of room for development, because the modern people's lifestyle is slowly transformed into self-cultivation, and flower cultivation has become a hobby in their lives. Flower pots are produced through injection molds, with short production cycle, large output, and long tool life. . Flower pot molds will be manufactured by more and more people. 1. The flower pot mould has the bottom touch perforation and the side wall touch perforation to achieve water leakage (to prevent too much watering at one time to make the flowers rotten). The bottom leakage design is directly through the direct core cavity, and the punching cannot be too small, because it is too small to require high-precision machining, and the cost will increase. The sidewall leakage design uses the cylinder core to achieve the collision, which is a challenge to the complexity of the mold structure. The production cycle of the product will also be lengthened. 2. The economic b...

  How is plastic bucket mold made? Bucket mold  is one of our most important plastic injection mold, our bucket mold includes thin wall bucket mold, food bucket mold, pail mold, cylinder bucket mold, square shape bucket mold,cuboid bucket mold, industrial use bucket and pail mold, water bucket mold, industrial paint bucket mold, fishing bucket mold, packing bucket mold, dustbin bucket mold,cement pail mold, plastic barrel mold and other bucket molds. Firstly, Mold Design and Structure A high-quality mold structure is a premise for a qualified mold before manufacturing.We attach great importance to analyze mold structure, including demolding draft angle, the epitome of product surface, gating system design, exhaust design, cooling system design etc.The main problems that may easily occur will through trial and error during the mold structure design. Second, the Mold Steel In order to improve the mold life and product quality, we increase the mold steel hardness through heat tre...

  How to avoid plastic mold rusting? Typically the  mould rusting  is caused by the gas produced by the melt overheating decomposition. If happened in molding, that is because the corrosion gas existing around rusts the mould. For this reason, we must use a dry and soft cloth to clean the mould when injection molding stops. If don't need molding production, we should close the mould to prevent gas generated from other injection machines cause corrosion. When close the mould, please remember to paint grease and do not forget to plug into the pouring type. If do not use the mould for a long time, we should spray anti-rust agent in the mould cavities. And make sure you have cleaned the cavity inside before painting If there is coated carbide slag on the cavity surface, should be immediately removed. The carbide separates out and decomposes from molding material can easily get mould corrosion, so once discover, we should clean with a dry cloth. Usually the plating layer in th...